BMW R 1250 RT - Owner's Manual > Range
The range readout indicates how far you can ride with the fuel remaining in the tank. The figure for average consumption used to calculate range is not shown and might not be the same as the average-consumption reading that appears on the display.
You must put at least five litres of fuel into the fuel tank for the new level to be registered correctly.
If the sensor cannot register the new level the range readout cannot be updated.
When the motorcycle is propped on its side stand the slight angle of inclination means that the sensor cannot register the fuel level correctly. This is the reason why the range is calculated only when the side stand is in the retracted position.
NOTICE The calculated range is only an approximate figure. Consequently, BMW Motorrad recommends that you should not try to use the full range before refuelling.
Electronic oil-level check
The electronic oil-level check provides information about the oil level in the engine.
The preconditions for the electronic oil-level check are as follows:
-
Engine at operating temperature.
-
Engine idling for at least ten seconds.
-
No brake applied.
-
Side stand folded in.
-
Motorbike standing upright.
The readings mean:
OK: oil level is correct.
CHECK!: check the oil level the next time you stop for fuel.
- - -: oil level cannot be measured (conditions as stated above not satisfied).
Ambient temperature
When the motorcycle is at a standstill the heat of the engine can falsify the ambienttemperature reading. If the effect of the engine's heat becomes excessive, "--" temporarily appears on the display.
If ambient temperature drops below the threshold this warning appears, drawing your attention to the risk of black ice forming. The display automatically switches from any other mode to the temperature reading when the temperature drops below this threshold for the first time.
Tyre pressures
- with tyre pressure control (RDC) OE
The left value 1 indicates the filling pressure of the front wheel; the right value 2 indicates the filling pressure of the rear wheel.
Immediately after the ignition is switched on "-- --" is displayed.
In the event of a critical tyre inflation pressure, the relevant display appears red.
The tyre warning symbol is also displayed.
The general warning light flashes red.
You can find further information about BMW Motorrad RDC.
See also:
BMW R 1250 RT - Owner's Manual > Hill Start Control active
Green holding symbol is displayed. Possible cause: Hill Start Control has been activated automatically or activated by the rider. Operate Hill Start Control.